Home Improvement with Diydoctor

 

Cutting a mitred joint. Fixing skirting boards and dado rails.

Back to full list of projects

 

 

CUTTING A MITRED JOINT:

Where two pieces of skirting board, picture or dado rail  meet in the corner of a room, the chances are that the neat joint between the two sides is made using a mitre. This is an angled cut made to both pieces of timber.

The angle at which each piece of timber is cut is half of the total angle involved. For example, most rooms are square, or very nearly in the case of most modern buildings! This gives each corner a value of 90 degrees. Both sides of the timber are therefore cut at 45 degrees so the meet to form the 90 degree turn.

The length of one side of the wall is measured and at each end a mitre is cut. Don't forget that mitres at each end will turn the opposite way. These mitres are very  easily cut with a mitre saw. The best saw to use is a tenon saw as it has very fine teeth and will not "tear" the timber.

As with all timber joints, use an off-cut of timber to practice on first. It is worth buying an additional length of skirting for example to practice joining two mitres as, unless you are used to it, they can get out of line quite easily. When using a mitre saw, clamp the timber in tightly, even a little movement can lead to a bad joint.

If your joints are not perfect, and to start with it is unlikely that they will be, you can fill them with some flexible filler, or "decorators caulk" and, done properly, this will not show.

Angle finders can be bought at most Diy stores, but a simple way of checking you have exactly half of the room angle is to cut a piece of paper into the corner so both sides of the paper touch a wall each. Then fold the paper in half so that each of the sides which were touching a wall are now aligned with each other. The angle now formed can be marked onto the timber. When cut and joined, the two timbers should be like unfolding the paper again. Don't forget, practice first.

Angle finder.

 

If you have a lot of mitres to do it is definately worth buying an electric mitre or "chop" saw, but do remember to wear safety goggles.

 

Click on the images below to buy the tools.

                                

                     Chisel set 9.99                                        Tenon saw  3.99                                   Screwdriver set 19.99

 

                              

                                 Flexible filler                                Applicator gun                                         Wood filler

 

                                 

                                     Hand mitre saw 19.99                                                 Electric mitre saw 49.00

 

Fill holes easily in plasterboard walls, hollow doors, car bodies and boat shells

ITS A MIRACLE !!

Much more construction information is available in our bookstore. All the tools and plumbing fittings you need in the toolstore